GRUEN INTERNATIONAL SCHOOLS, PORT HARCOURTMicro soldering is precision soldering work performed on small electronic components and PCB connections. It is common in GSM and other electronic repairs where components and tracks are very small.
Typical tools include a temperature-controlled soldering iron, suitable fine tip, hot-air rework station where appropriate, solder, flux, solder wick, tweezers, microscope or magnifying inspection equipment, PCB holder, cleaning materials and ESD protection.
Confirm the faulty IC using proper diagnosis. Protect surrounding components, apply suitable flux and controlled heat, remove the component carefully, clean the pads, inspect for damage, position the replacement correctly, solder/reflow using appropriate technique, clean the board and inspect under magnification.
A jumper is a small insulated or enamelled wire used to restore an interrupted electrical connection. The technician identifies the correct points from the schematic/board layout, prepares the connection, secures the wire and verifies continuity before powering the board.
Solder bridge: unintended connection between adjacent pads. Cold joint: poor electrical/mechanical connection. Lifted pad: PCB pad separates from the board due to excessive heat or force. Excess solder and flux residue can also cause problems.
After soldering, inspect joints under magnification, check for bridges and damaged tracks, clean appropriate residues, test continuity where required and perform functional testing using safe power conditions.
Avoid excessive heat and prolonged heating. Protect eyes and skin from hot tools. Maintain ventilation when using soldering materials. Use ESD precautions and never work on an energised board unless the procedure specifically requires it and safe test methods are being followed.
Practical / Learner Activity
Teacher demonstrates soldering on a practice PCB. Students practise identifying pads, applying flux, making simple joints and checking continuity on a de-energised board.
Assignment
1.What is micro soldering?
2.Mention five tools used in precision soldering.
3.What is a solder bridge?
4.Explain the purpose of a jumper wire.
5.State three precautions to observe during micro soldering.